Specifications - State of Delaware

SECTION 081113 - HOLLOW METAL DOORS AND FRAMES: continued
b. Frames: Show profile, corner joint, floor and wall anchors, and silencers. Include
separate section showing fixed hollow metal panels and glazing if applicable.
E. Other Submittals:
1. Schedule: Provide a schedule of hollow metal work prepared by or under the supervision
of supplier, using same reference numbers for details and openings as those on Drawings.
Coordinate with door hardware schedule.
F. LEED Submittals:
1. Product Data for Credit MRc4: For products containing recycled content, submit
documentation indicating percentages, by weight, of post-consumer and pre-consumer
recycled content for each product or portion of a product having recycled content.
Include statement indicating cost for each product containing recycled content material.
2. Product Data for Credit MRc5: For products and materials complying with requirements
for regional materials, submit documentation indicating location and distance from
Project of material manufacturer and point of extraction, harvest, or recovery for each
raw material. Include statement indicating cost for each regional material and the
fraction by weight that is considered regional.
1.06 INFORMATIONAL SUBMITTALS:
A. Oversize Construction Certification: For assemblies required to be fire rated and exceeding
limitations of labeled assemblies.
B. Product Test Reports: Based on evaluation of comprehensive tests performed by a qualified
testing agency, for each type of hollow metal door and frame assembly.
1.07 QUALITY ASSURANCE:
A. Source Limitations: Obtain hollow metal work from single source from single manufacturer.
B. Fire-Rated Door Assemblies: Assemblies complying with NFPA 80 that are listed and labeled
by a qualified testing agency, for fire-protection ratings indicated, based on testing at positive
pressure according to NFPA 252.
1. Temperature-Rise Limit: At vertical exit enclosures and exit passageways, provide doors
that have a maximum transmitted temperature end point of not more than 450ºF above
ambient after 30 minutes of standard fire-test exposure.
1.08 DELIVERY, STORAGE, AND HANDLING:
A. Deliver hollow metal work palletized, wrapped, or crated to provide protection during transit
and Project-site storage. Do not use nonvented plastic.
1. Provide additional protection to prevent damage to finish of factory-finished units.
B. Deliver welded frames with two removable spreader bars across bottom of frames, tack welded
to jambs and mullions.
C. Store hollow metal work under cover at Project site. Place in stacks of five units maximum in
a vertical position with heads up, spaced by blocking, on minimum 4-inch high wood blocking.
Do not store in a manner that traps excess humidity.
1. Provide minimum 1/4-inch space between each stacked door to permit air circulation.
1.09 PROJECT CONDITIONS:
A. Field Measurements: Verify actual dimensions of openings by field measurements before
fabrication.
1.10 COORDINATION:
A. Coordinate installation of anchorages for hollow metal frames. Furnish setting drawings,
templates, and directions for installing anchorages, including sleeves, concrete inserts, anchor
DEAN081113.DOC 081113-3