Specifications - State of Delaware

SECTION 102800 - TOILET, BATH, AND LAUNDRY ACCESSORIES
PART 1 - GENERAL
1.01 RELATED DOCUMENTS:
A. Drawings and general provisions of the Contract, including General and Supplementary
Conditions and DIVISION 01 Specification Sections, apply to this Section.
B. DIVISION 01, Section "Sustainable Design Requirements" for LEED ® related requirements
for recycled content materials and local/regionally manufactured and sourced materials.
1.02 SUMMARY:
A. Section Includes:
1. Public-use washroom accessories.
2. Warm-air dryers.
3. Custodial accessories.
1.03 REFERENCES:
A. ASTM International:
1. ASTM A153/A153M-05 - Specification for Zinc Coating (Hot-Dip) on Iron and Steel
Hardware.
2. ASTM A653/A653M-06a - Specification for Steel Sheet, Zinc-Coated (Galvanized) or
Zinc-Iron Alloy-Coated (Galvannealed) by the Hot-Dip Process.
3. ASTM A666-03 - Specification for Annealed or Cold-Worked Austenitic Stainless Steel
Sheet, Strip, Plate, and Flat Bar.
4. ASTM A1008/A1008M-07 - Specification for Steel, Sheet, Cold-Rolled, Carbon,
Structural, High-Strength Low-Alloy, High-Strength Low-Alloy with Improved
Formability, Solution Hardened, and Bake Hardenable.
5. ASTM B16/B16M-05 - Specification for Free-Cutting Brass Rod, Bar and Shapes for
Use in Screw Machines.
6. ASTM B19-05 - Specification for Cartridge Brass Sheet, Strip, Plate, Bar, and Disks.
7. ASTM B30-06a - Specification for Copper Alloys in Ingot Form.
8. ASTM B456-03 - Specification for Electrodeposited Coatings of Copper Plus Nickel Plus
Chromium and Nickel Plus Chromium.
9. ASTM C1503-01 - Specification for Silvered Flat Glass Mirror.
10. ASTM F446-85 (Reapproved 2004) - Consumer Safety Specification for Grab Bars and
Accessories Installed in the Bathing Area.
B. NFPA 70-2008 - National Electrical Code.
1.04 SUBMITTALS:
A. Product Data: For each type of product indicated. Include the following:
1. Construction details and dimensions.
2. Anchoring and mounting requirements, including requirements for cutouts in other work
and substrate preparation.
3. Material and finish descriptions.
4. Features that will be included for Project.
5. Manufacturer's warranty.
B. Samples: Full size, for each accessory item to verify design, operation, and finish
requirements.
1. Approved full-size Samples will be returned and may be used in the Work.
DEAN102800.DOC 102800-1