Specifications - State of Delaware

SECTION 084113 - ALUMINUM-FRAMED ENTRANCES AND STOREFRONTS: continued
E. Builders Hardware Manufacturers Association:
1. BHMA A156.1 (2000) - Butts and Hinges (ANSI).
2. BHMA A156.3 (2001) - Exit Devices (ANSI).
3. BHMA A156.4 (2000) - Door Controls - Closers (ANSI).
4. BHMA A156.5 (2001) - Auxiliary Locks & Associated Products (ANSI).
5. BHMA A156.6 (2001) - Architectural Door Trim (ANSI).
6. BHMA A156.8 (2000) - Door Controls - Overhead Stops and Holders (ANSI).
7. BHMA A156.16 (2002) - Auxiliary Hardware (ANSI).
8. BHMA A156.21 (2001) - Thresholds (ANSI).
F. International Code Council:
1. ICC/ANSI A117.1 (2003) - Accessible and Usable Buildings and Facilities.
G. SSPC - The Society for Protective Coatings:
1. SSPC-Paint 12 (1982) - Paint Specification No. 12 - Cold-Applied Asphalt Mastic (Extra
Thick Film).
2. SSPC-PS Guide No. 12.00 (2002) (Revised 2004) - Guide to Zinc-Rich Coating Systems.
3. SSPC-SP COM (2004) - Surface Preparation Specifications - Surface Preparation
Commentary for Steel and Concrete Substrates.
H. Underwriters Laboratories, Inc.:
1. UL 305 (1997) - Panic Hardware.
I. U.S. Architectural & Transportation Barriers Compliance Board:
1. Americans with Disabilities Act (ADA) and Architectural Barriers Act (ABA)
Accessibility Guidelines for Buildings and Facilities. Adopted in 2004.
J. Department of Defense Unified Facilities Criteria (UFC):
1. 4-010-01 - DoD Minimum Antiterrorism Standards for Buildings.
2. 4-010-02 - DoD Minimum Antiterrorism Standoff Distances for Buildings (FOUO).
1.04 DEFINITIONS:
A. ADA/ABA Accessibility Guidelines: U.S. Architectural & Transportation Barriers
Compliance Board's "Americans with Disability Act (ADA) and Architectural Barriers Act
(ABA) Accessibility Guidelines for Buildings and Facilities."
1.05 PERFORMANCE REQUIREMENTS:
A. General Performance: Aluminum-framed systems shall withstand the effects of the following
performance requirements without exceeding performance criteria or failure due to defective
manufacture, fabrication, installation, or other defects in construction:
1. Movements of supporting structure indicated on Drawings including, but not limited to,
story drift and deflection from uniformly distributed and concentrated live loads.
2. Dimensional tolerances of building frame and other adjacent construction.
3. Failure includes the following:
a. Deflection exceeding specified limits.
b. Thermal stresses transferring to building structure.
c. Framing members transferring stresses, including those caused by thermal and
structural movements to glazing.
d. Glazing-to-glazing contact.
e. Noise or vibration created by wind and by thermal and structural movements.
f. Loosening or weakening of fasteners, attachments, and other components.
g. Sealant failure.
h. Failure of operating units.
DEAN084113.DOC 084113-3