Specifications - State of Delaware

SECTION 084113 - ALUMINUM-FRAMED ENTRANCES AND STOREFRONTS
PART 1 - GENERAL
1.01 RELATED DOCUMENTS:
A. Drawings and general provisions of the Contract, including General and Supplementary
Conditions and DIVISION 01 Specification Sections, apply to this Section.
1.02 SUMMARY:
A. This Section Includes:
1. Exterior and interior storefront framing.
2. Exterior and interior manual-swing entrance doors and door-frame units.
B. Related Sections:
1. DIVISION 01, Section "Sustainable Design Requirements" for LEED ® related
requirements for recycled content materials and local/regionally manufactured and
sourced materials.
2. DIVISION 08, Section "Automatic Entrances" for automatic entrances.
1.03 REFERENCES:
A. American Architectural Manufacturers Association:
1. AAMA 501.1 (2005) - Standard Test Method for Water Penetration of Windows, Curtain
Walls, and Doors Using Dynamic Pressure.
2. AAMA 501.2 (2003) - Quality Assurance and Diagnostic Water Leakage Field Check of
Installed Storefronts, Curtain Walls, and Sloped Glazing Systems.
3. AAMA 501.4 (2000) (Revised 2001) - Recommended Static Test Method for Evaluating
Curtain Wall and Storefront Systems Subjected to Seismic and Wind Induced Interstory
Drifts.
4. AAMA 501.5 (2005) - Test Method for Thermal Cycling of Exterior Walls.
5. AAMA 506 (2000) (Revised 2003) - Voluntary Specifications for Hurricane Impact and
Cycle Testing of Fenestration Products.
6. AAMA 611 (1998) - Voluntary Specification for Anodized Architectural Aluminum.
7. AAMA 701 (2000) - Voluntary Specifications for Pile Weatherstripping.
8. AAMA 1503 (1998) - Voluntary Test Method for Thermal Transmittance and
Condensation Resistance of Windows, Doors and Glazed Wall Sections.
9. AAMA 2603 (2002) - Voluntary Specification, Performance Requirements and Test
Procedures for Pigmented Organic Coatings on Aluminum Extrusions and Panels.
10. AAMA 2604 (2002) - Voluntary Specification, Performance Requirements and Test
Procedures for High Performance Organic Coatings on Aluminum Extrusions and Panels.
11. AAMA 2605 (2002) - Voluntary Specification, Performance Requirements and Test
Procedures for Superior Performing High Performance Organic Coatings on Aluminum
Extrusions and Panels.
B. American Welding Society:
C. AWS A5.10 (1999) - Specification for Bare Aluminum and Aluminum-Alloy Welding
Electrodes and Rods.
1. AWS D1.2 (2003) - Structural Welding Code - Aluminum.
D. ASTM International:
1. ASTM A36-05 - Specification for Carbon Structural Steel.
2. ASTM A123-02 - Specification for Zinc (Hot-Dip Galvanized) Coatings on Iron and
Steel Products.
3. ASTM A153-04 - Specification for Zinc Coating (Hot-Dip) on Iron and Steel Hardware.
DEAN084113.DOC 084113-1