Specifications - State of Delaware

SECTION 133423 - FABRICATED STRUCTURES: continued
3. Insulated Exterior/Interior Panel: Fabricated from 0.028-inch nominal-thickness,
galvanized-steel, 0.032-inch thick, aluminum sheet faces and expanded-foam insulation
core.
a. Thermal Resistance Value (R-Value): R-17.
4. Downspouts: Integral, extending 3 inches beyond booth walls.
5. Roof gutters.
F. Swinging Door: 1-3/4 inches thick; tubular-frame design fabricated from galvanized steel;
with top half of door glazed. Equip door with deadlock, three butt hinges, closer, and full
weather stripping.
1. Deadlock: Mortised, with lever handle and removable cylinder capable of being master
keyed.
G. Finish: Finish exposed metal surfaces, including structural framework, walls, canopy, and
ceiling with rust-inhibitive primer and one finish coat of industrial air-dry acrylic enamel.
1. Color: As selected by Contracting Officer from manufacturer's full range.
2.04 FABRICATION:
A. Fabricate enclosure completely in factory.
B. Preglaze enclosure doors at factory.
C. Prewire enclosure at factory, ready for connection to service at Project site.
D. Fabricate enclosure with forklift pockets in base of enclosure.
2.05 GENERAL FINISH REQUIREMENTS:
A. Comply with NAAMM's "Metal Finishes Manual for Architectural and Metal Products" for
recommendations for applying and designating finishes.
B. Appearance of Finished Work: Noticeable variations in same piece are not acceptable.
Variations in appearance of adjoining components are acceptable if they are within the range of
approved Samples and are assembled or installed to minimize contrast.
2.06 FINISHES:
A. Steel Factory Finish: Immediately after cleaning and pretreating, apply manufacturer's
standard two-coat, baked-on finish consisting of prime coat and thermosetting topcoat.
1. Color and Gloss: As selected by Contracting Officer from manufacturer's full range.
B. Baked-Enamel or Powder-Coat Finish: AAMA 2603 except with a minimum dry film
thickness of 1.5 mils. Comply with coating manufacturer's written instructions for cleaning,
conversion coating, and applying and baking finish.
1. Color and Gloss: As selected by Contracting Officer from manufacturer's full range.
PART 3 - EXECUTION
3.01 EXAMINATION:
A. Examine substrates, areas, and conditions, with Installer present, for compliance with
requirements for installation tolerances and other conditions affecting performance of the
Work.
B. Prepare written report, endorsed by Installer, listing conditions detrimental to performance of
the Work.
C. Proceed with installation only after unsatisfactory conditions have been corrected.
3.02 INSTALLATION:
A. Install enclosure according to manufacturer's written instructions.
DEAN133423.DOC 133423-5