Specifications - State of Delaware

SECTION 085113 - ALUMINUM WINDOWS: continued
6. ASTM E1886-05 - Test Method for Performance of Exterior Windows, Curtain Walls,
Doors, and Impact Protective Systems Impacted by Missile(s) and Exposed to Cyclic
Pressure Differentials.
7. ASTM E1996-08 - Specification for Performance of Exterior Windows, Curtain Walls,
Doors and Impact Protective Systems Impacted by Windborne Debris in Hurricanes.
8. ASTM E2190-08 - Specification for Insulating Glass Unit Performance and Evaluation.
9. ASTM E2112-07 - Practice for Installation of Exterior Windows, Doors and Skylights.
10. ASTM F1642-04 (Reapproved 2010) - Test Method for Glazing and Glazing Systems
Subject to Airblast Loadings.
11. ASTM F2248-09 - Practice for Specifying an Equivalent 3-Second Duration Design
Loading for Blast Resistant Glazing Fabricated with Laminated Glass.
D. Forest Stewardship Council:
1. FSC STD-01-001-2004 - FSC Principles and Criteria for Forest Stewardship (available in
PDF at www.fsc.org).
2. FSC STD-40-004-2008 - FSC Standard for Chain of Custody Certification (available in
PDF at www.fsc.org).
E. National Association of Architectural Metal Manufacturers:
1. Metal Finishes Manual, 2006.
F. National Fenestration Rating Council:
1. NFRC 100-2004 (Revised 2008) - Procedure for Determining Fenestration Product
U-Factors.
2. NFRC 200-2004 (Revised 2008) - Procedure for Determining Fenestration Product Solar
Heat Gain Coefficients and Visual Transmittance at Normal Incidence.
G. Department of Defense Unified Facilities Criteria (UFC):
1. 4-010-01 - DoD Minimum Antiterrorism Standards for Buildings.
2. 4-010-02 - DoD Minimum Antiterrorism Standoff Distances for Buildings (FOUO).
1.04 SUBMITTALS:
A. Product Data: For each type of product.
1. Include construction details, material descriptions, glazing and fabrication methods,
dimensions of individual components and profiles, hardware, and finishes for aluminum
windows.
B. Shop Drawings: Include plans, elevations, sections, hardware, accessories, insect screens,
operational clearances, and details of installation, including anchor, flashing, and sealant
installation.
C. Samples: For each exposed product and for each color specified, 2 by 4 inches in size.
D. Samples for Initial Selection: For units with factory-applied color finishes.
1. Include similar Samples of hardware and accessories involving color selection.
E. Samples for Verification: For aluminum windows and components required, showing full
range of color variations for finishes, and prepared on Samples of size indicated below:
1. Exposed Finishes: 2 by 4 inches.
2. Exposed Hardware: Full-size units.
F. Product Schedule: For aluminum windows. Use same designations indicated on Drawings.
G. Blast Testing or Analysis Reports: Submit one or more of the following as necessary to
demonstrate compliance with all specified requirements for blast resistance.
1. Static test results in accordance with ASTM E330.
2. Airblast test results in accordance with ASTM F1642.
3. Structural analysis data prepared by or under the supervision of a professional engineer
experienced in the design of blast-resistant glazing systems.
085113-2 DEAN085113.DOC