Specifications - State of Delaware

SECTION 101400 - SIGNAGE: continued
17. ASTM D790-03 - Test Method for Flexural Properties for Unreinforced and Reinforced
Plastics and Electrical Insulating Materials.
18. ASTM D1044-99 - Test Method for Resistance of Transparent Plastics to Surface
Abrasion.
19. ASTM D4802-02 - Specification for Poly (Methyl Methacrylate) Acrylic Plastic Sheet.
C. International Code Council/American National Standards Institute:
1. ICC/ANSI A117.1-98 - Accessible and Usable Buildings and Facilities.
D. National Association of Architectural Metal Manufacturers:
1. Metal Finishes Manual for Architectural and Metal Products, 1988.
E. SSPC - The Society for Protective Coatings:
1. SSPC-SP 5/NACE No. 1 2000 - Joint Surface Preparation Standard SSPC-SP 5/NACE
No. 1 - White Metal Blast Cleaning.
2. SSPC-SP 8 1982 (Revised 2000) - Surface Preparation Specification No. 8: Pickling.
F. Underwriters Laboratories Inc.:
1. UL 924-01 - Emergency Lighting and Power Equipment.
G. U.S. Architectural & Transportation Barriers Compliance Board:
1. Americans with Disabilities Act (ADA) Accessibility Guidelines for Build.
1.04 DEFINITIONS:
A. ADA-ABA Accessibility Guidelines: U.S. Architectural & Transportation Barriers
Compliance Board's "Americans with Disabilities Act (ADA) Accessibility Guidelines for
Buildings and Facilities; Architectural Barriers Act (ABA) Accessibility Guidelines."
1.05 SUBMITTALS:
A. Product Data: For each type of product indicated.
B. Shop Drawings: Show fabrication and installation details for signs.
1. Show sign mounting heights, locations of supplementary supports to be provided by
others, and accessories.
2. Provide message list, typestyles, graphic elements, including tactile characters and
Braille, and layout for each sign.
3. Wiring Diagrams: Power, signal, and control wiring.
C. Samples: For each of the following products and for the full range of color, texture, and sign
material indicated, of sizes indicated:
1. Dimensional Characters: Full-size Samples of each type of dimensional character (letter,
number, and graphic element).
2. Aluminum: For each form, finish, and color, on 6-inch long sections of extrusions and
squares of sheet at least 4 by 4 inches.
3. Acrylic Sheet: 8 by 10 inches for each color required.
4. Polycarbonate Sheet: 8 by 10 inches for each color required.
5. Panel Signs: Not less than 12 inches square including border.
D. Sign Schedule: Use same designations indicated on Drawings.
E. LEED Submittals:
1. Product Data for Credit MRc4: For products containing recycled content, submit
documentation indicating percentages, by weight, of post-consumer and pre-consumer
recycled content for each product or portion of a product having recycled content.
Include statement indicating cost for each product containing recycled content material.
2. For products and materials complying with requirements for regional materials, submit
documentation indicating location and distance from Project of material manufacturer
and point of extraction, harvest, or recovery for each raw material. Include statement
101400-2 DEAN101400.DOC