Specifications - State of Delaware

SECTION 101100 – MARKERBOARDS AND TACKBOARDS: continued
3. Room 115, 25U Classroom: Two - 4'-0" wide by 4'-0" high units.
4. Room 131, Training Room 1: One - 4'-0" wide by 4'-0" high unit.
5. Room 132, Training Room 2: One - 4'-0" wide by 4'-0" high unit.
6. Room 133, Training Room 3: One - 4'-0" wide by 4'-0" high unit.
7. Room 134, Training Room 4: One - 4'-0" wide by 4'-0" high unit.
8. Mount bottom of unit at 3'-0" above floor.
2.06 FABRICATION:
A. Provide factory-built units completely assembled in one piece without joints, whenever
possible.
B. Where dimensions exceed panel size, provide two or more pieces of equal length as acceptable
to Contracting Officer.
C. When overall dimensions require delivery in separate units, prefit at factory, disassemble for
delivery, and make final joints at site.
D. Use splines at joints to maintain surface alignment.
PART 3 - EXECUTION
3.01 INSTALLATION:
A. Install units plumb and level, and conforming to manufacturer's printed instructions.
B. Install all anchors and units securely to substrate. Provide all grounds, clips, backing materials,
adhesives, brackets, anchors, trim, and accessories for complete installation.
3.02 CLEANING:
A. Clean all surfaces after installation.
B. Replace or repair damaged surfaces.
C. Protect units from damage.
END OF SECTION 101100
DEAN101100.DOC 101100-3