Specifications - State of Delaware

SECTION 260000 - BASIC ELECTRICAL REQUIREMENT: continued
1.06 DELIVERY, STORAGE, AND HANDLING:
A. Deliver products to the Project Site properly identified with names, model numbers, types,
grades, compliance labels, and other information needed for identification.
1.07 WARRANTY:
A. Provide a minimum 1-year warranty on all electrical Equipment. Warranty period shall begin
when Equipment is permanently energized or started unless specified otherwise. Contractor
shall provide written notification to Contracting Officer's Representative prior to this warranty
start date.
B. Warranty on lamps and fixture shall start at building occupancy.
1.08 INSTRUCTIONS, TRAINING, AND MANUFACTURER'S SERVICE REPRESENTATIVE:
A. Provide instructions and training of Contracting Officer's personnel as specified.
B. Provide services of a manufacturer's authorized service representative as specified.
PART 2 - PRODUCTS
2.01 Unless indicated otherwise, all Equipment and Material shall be new, undamaged and meet the
requirements of Underwriters Laboratories, Inc. (UL). Where UL requirements are not
applicable, equipment and material shall be identified as such by Contractor and approved by
Contracting Officer before purchase and installation.
2.02 LEED REQUIREMENTS:
A. See SECTION 018113 - SUSTAINABLE DESIGN REQUIREMENTS for LEED
requirements pertaining to VOC limits for site-applied interior adhesives, sealants, paints and
coatings.
2.03 ELECTRONIC EQUIPMENT COMPLIANCE:
A. Contractor warrants that all equipment, devices, items, systems, software, hardware, or
firmware provided shall properly, appropriately, and consistently function and accurately
process date and time data (including without limitation: calculating, comparing, and
sequencing). This warranty supersedes anything in the Specifications or other Contract
Documents which might be construed inconsistently. This warranty is applicable whether the
equipment, device, item, system, software, hardware, or firmware is specified with or without
reference to a manufacturer's name, make, or model number.
PART 3 - EXECUTION
3.01 ROUGH-IN:
A. Verify final locations for rough-ins with field measurements and with the requirements of the
actual Equipment to be connected.
B. Refer to Equipment Specifications in DIVISIONS 01 through 48 and the Equipment
Submittals for rough-in requirements.
DEAN260000.DOC 260000-3