Specifications - State of Delaware

SECTION 087100 - DOOR HARDWARE
PART 1 - GENERAL
1.01 RELATED DOCUMENTS:
A. Drawings and general provisions of the Contract, including General and Supplementary
Conditions and DIVISION 01 Specification Sections, apply to this Section.
B. DIVISION 01, Section "Sustainable Design Requirements" for LEED ® related requirements
for recycled content materials and local/regionally manufactured and sourced materials.
1.02 SUMMARY:
A. Section includes:
1. Mechanical door hardware for the following:
a. Swinging doors.
2. Cylinders for door hardware specified in other Sections.
B. Related Sections:
1. DIVISION 06, Section "Interior Architectural Woodwork" for cabinet door hardware
provided as part of architectural woodwork.
2. DIVISION 08, Section "Hollow Metal Doors and Frames".
3. DIVISION 08, Section "Aluminum Frames" for door silencers provided as part of
aluminum frames.
4. DIVISION 08, Section "Flush Wood Doors" provided as part of labeled fire-rated
assemblies.
5. DIVISION 08, Section "Aluminum-Framed Entrances and Storefronts" for entrance door
hardware, including cylinders.
1.03 REFERENCES:
A. American National Standards Institute:
1. ANSI/SDI A250.6-2003 - Recommended Practice for Hardware Reinforcing on Standard
Steel Doors and Frames.
2. ANSI/SDI A250.8-2003 - Recommended Specifications for Standard Steel Doors and
Frames.
B. ASTM International:
1. ASTM E283-04 - Test Method for Determining the Rate of Air Leakage through Exterior
Windows, Curtain Walls, and Doors under Specified Pressure Differences across the
Specimen.
C. Builders Hardware Manufacturers Association:
1. BHMA A156.1-2006 - Butts and Hinges (ANSI).
2. BHMA A156.2-2003 - Bored and Preassembled Locks & Latches (ANSI).
3. BHMA A156.3-2001 - Exit Devices (ANSI).
4. BHMA A156.4-2000 - Door Controls - Closers (ANSI).
5. BHMA A156.5-2001 - Auxiliary Locks and Associated Products (ANSI).
6. BHMA A156.6-2005 - Architectural Door Trim (ANSI).
7. BHMA A156.13-2005 - Mortise Locks & Latches Series 1000 (ANSI).
8. BHMA A156.16-2002 - Auxiliary Hardware (ANSI).
9. BHMA A156.17-2004 - Self Closing Hinges & Pivots (ANSI).
10. BHMA A156.18-2006 - Materials and Finishes (ANSI).
11. BHMA A156.21-2006 - Thresholds (ANSI).
12. BHMA A156.22-2005 - Door Gasketing and Edge Seal Systems (ANSI).
13. BHMA A156.26-2006 - Continuous Hinges (ANSI).
14. BHMA A156.28-2000 - Recommended Practices for Keying Systems (ANSI).
DEAN087100.DOC 087100-1