Specifications - State of Delaware

SECTION 265610 - EXTERIOR LIGHTING FIXTURES: continued
A. Examine areas and conditions under which lighting fixtures are to be installed and the substrate
which will support lighting fixtures. Do not proceed with the Work until unsatisfactory
conditions have been corrected.
3.02 INSTALLATION OF EXTERIOR LIGHTING FIXTURES:
A. Install exterior lighting fixtures at locations and heights as indicated, in accordance with fixture
manufacturer's written instructions, applicable requirements of NEC, NECA's "Standard of
Installation," NEMA standards, and with recognized industry practices to ensure that lighting
fixtures fulfill requirements.
B. Tighten connectors and terminals, including screws and bolts, in accordance with equipment
manufacturer's published torque tightening values for equipment connectors. Where
manufacturer's torquing requirements are not indicated, tighten connectors and terminals to
comply with tightening torques specified in UL 486A and the National Electrical Code.
C. Fasten electrical lighting fixtures and brackets securely to structural supports, including
poles/standards; ensure that installed fixtures are plumb and level.
D. All exterior lighting shall be demonstrated during night time tests.
E. All light fixtures which can be aimed (floodlights, etc.) shall be aimed as indicated and shall be
re-aimed as directed by Contracting Officer during night time lighting demonstrations.
Redemonstrate lighting at night after all adjustments have been made.
F. All conduit entering building shall be sealed to prevent water and/or insects entering building
from light fixtures.
3.03 GROUNDING:
A. Provide equipment grounding connections for exterior lighting fixtures as indicated. Tighten
connections to comply with tightening torques specified in UL 486A to assure permanent and
effective grounds.
3.04 FIELD QUALITY CONTROL:
A. At the Date of Substantial Completion, replace lamps in exterior lighting fixtures which are
observed to be noticeably dimmed after Contractor's use and testing, as judged by Contracting
Officer.
B. Refer to DIVISION 01 Sections for the replacement/restoration of lamps in exterior lighting
fixtures where used for temporary lighting prior to Date of Substantial Completion.
3.05 ADJUSTING AND CLEANING:
A. Aim adjustable lighting fixtures and lamps in night test of system. Verify that measured
illuminance values comply with submitted isolux plot diagram values.
B. Clean lighting fixtures of dirt and debris upon completion of installation.
C. Protect installed fixtures from damage during construction period.
D. Photoelectric Controls:
1. Aim "north."
2. Adjust to actuate "on" at 3.0 footcandles.
3. Provide FAA listed photoelectric controls for control of aviation obstruction lighting.
265610-4 DEAN265610.DOC