Specifications - State of Delaware

SECTION 133423 - FABRICATED STRUCTURES: continued
15. ASTM E774-97 - Specification for the Classification of the Durability of Sealed
Insulating Glass Units.
16. ASTM F2329-05 - Specification for Zinc Coating, Hot-Dip, Requirements for
Applications to Carbon and Alloy Steel Bolts, Screws, Washers, Nuts and Special
Threaded Fasteners.
F. Code of Federal Regulations:
1. 16 CFR 1201-2005 - Safety Standard for Architectural Glazing Materials.
G. Department of Commerce:
1. DOC PS 1-1995 - Construction and Industrial Plywood.
H. National Association of Architectural Metal Manufacturers:
1. Metal Finishes Manual for Architectural and Metal Products, 1988.
I. NFPA:
1. NFPA 70-2005 - National Electrical Code.
1.04 PERFORMANCE REQUIREMENTS:
A. Structural Performance: Control booths shall withstand the effects of gravity loads and the
following loads and stresses within limits and under conditions indicated according to:
1. Dead Loads: Per IBC.
2. Live Loads: Per IBC.
3. Roof Loads: 20 psf.
4. Snow Loads: 13 psf (flat-roof).
5. Seismic Design Category: B.
6. Wind Loads: 115 mph with 3-second gust.
7. Deflection Limits: Design framing system to withstand design loads without deflections
greater than the following:
a. Per IBC.
B. Thermal Movements: Allow for thermal movements from ambient and surface temperature
changes. Base calculations on surface temperatures of materials due to both solar heat gain
and nighttime-sky heat loss.
1. Temperature Change (Range): 120ºF, ambient; 180ºF, material surfaces.
1.05 SUBMITTALS:
A. Product Data: For each type of product indicated. Include construction details, material
descriptions, dimensions of individual components and profiles, and finishes for control
booths.
B. Shop Drawings: For control booths. Include plans, elevations, sections, details, and
attachments to other work.
C. Samples for Verification: For exposed finishes, in manufacturer's standard sizes.
1.06 INFORMATIONAL SUBMITTALS:
A. Welding certificates.
B. Warranty: Sample of special warranty.
1.07 CLOSEOUT SUBMITTALS:
A. Maintenance Data: For control booths to include in maintenance manuals.
1.08 QUALITY ASSURANCE:
A. Welding Qualifications: Qualify procedures and personnel according to the following:
1. AWS D1.1, "Structural Welding Code - Steel."
133423-2 DEAN133423.DOC