Specifications - State of Delaware

SECTION 260000 - BASIC ELECTRICAL REQUIREMENTS: continued
with other systems, installations, and building components. Drawings shall be prepared on
30- by 42-inch paper. Indicate locations where space is limited for installation and access and
where sequencing and coordination of installations are of importance to the efficient flow of
the Work, including (but not necessarily limited to) the following:
1. Indicate the proposed locations of major raceway systems, equipment, and materials.
2. Clearances for servicing equipment, including space for equipment disassembly required
for periodic maintenance.
3. Exterior wall and foundation penetrations.
4. Fire-rated wall and floor penetrations.
5. Equipment connections and support details.
6. Sizes and location of required concrete pads and bases.
7. Support details.
8. Indicate scheduling, sequencing, movement, and positioning of large equipment into the
building during construction.
9. Prepare floor plans, elevations, and appropriate details to indicate penetrations in floors,
walls, and ceilings, and their relationship to other penetrations and installations.
10. Prepare reflected ceiling plans to coordinate and integrate installations, air outlets, air
inlets, light fixtures, communications systems' components, sprinklers, speakers, heat
detectors, smoke detectors, and other ceiling-mounted devices.
1.04 RECORD DOCUMENTS:
A. Prepare record documents in accordance with the requirements in SECTION 017800 -
CONTRACT CLOSEOUT. In addition to the requirements specified in DIVISION 01,
indicate installed conditions for:
1. Major raceway systems, size and location for both exterior and interior; locations of
control devices; distribution and branch electrical circuitry; fuse sizes and circuit breaker
sizes and arrangements.
2. Equipment locations (exposed and concealed), dimensioned from prominent building
lines.
3. Approved substitutions, Contract Modifications, and actual Equipment and Materials
installed.
B. Engage the services of a licensed Land Surveyor or licensed Professional Engineer registered
in the state in which the Project is located to record the locations and invert elevations of
underground installations.
1.05 MAINTENANCE MANUALS:
A. Prepare maintenance manuals in accordance with SECTION 017800 - CONTRACT
CLOSEOUT. In addition to the requirements specified in DIVISION 01, include the following
information for Equipment items:
1. Description of function, normal operating characteristics and limitations, performance
curves, engineering data and tests, and complete nomenclature and commercial numbers
of replacement parts.
2. Manufacturer's printed operating procedures to include start-up, break-in, routine and
normal operating instructions; regulation, control, stopping, shutdown, and emergency
instructions; and summer and winter operating instructions.
3. Maintenance procedures for routine preventive maintenance and troubleshooting;
disassembly, repair, and reassembly; aligning and adjusting instructions.
4. Servicing instructions and lubrication charts and schedules.
5. "As-Built" schematic and wiring diagrams.
260000-2 DEAN260000.DOC