Specifications - State of Delaware

SECTION 124813 - ENTRANCE FLOOR MATS AND FRAMES: continued
1.07 QUALITY ASSURANCE:
A. Source Limitations: Obtain floor mats and frames through one source from a single
manufacturer.
B. Accessibility Requirements: Provide installed floor mats that comply with Section 4.5 in the
U.S. Architectural & Transportation Barriers Compliance Board's "Americans with Disabilities
Act (ADA), Accessibility Guidelines for Buildings and Facilities (ADAAG)."
1.08 PROJECT CONDITIONS:
A. Field Measurements: Indicate measurements on Shop Drawings.
1.09 COORDINATION:
A. Coordinate size and location of recesses in concrete with installation of finish floors to receive
floor mats and frames.
PART 2 - PRODUCTS
2.01 ENTRANCE MATS:
A. Available Manufacturers: Subject to compliance with requirements, manufacturers offering
products that may be incorporated into the Work include, but are not limited to, the following:
B. Basis of Design Product: Subject to compliance with requirements, provide:
1. American Floor Products Company, Inc.
2. ARDEN Architectural Specialties, Inc.
3. Balco, Inc.
4. Cactus Mat Mfg. Co.
5. Consolidated Plastics Company, Inc.
6. C/S Group.
7. Durable Corporation.
8. Flexco.
9. Matco International.
10. Mats, Inc.
11. Musson, R. C. Rubber Co.
12. Pawling Corporation; Architectural Products Division.
13. Sbemco International Inc.
14. Tennessee Mat Company, Inc.
15. Tepromark International, Inc.
16. U.S. Mat & Rubber Corporation.
17. Or approved equal.
C. Carpet-Type Mats: Nylon carpet bonded to 1/8- to 1/4-inch thick, flexible vinyl backing to
form mats 3/8 or 7/16 inch thick with nonraveling edges.
1. Colors, Textures, and Patterns: As selected by Contracting Officer from manufacturer's
full range.
2. Mat Size: 6 feet-0 inches wide by 10 feet-0 inches long, or as shown on Drawings.
D. Recessed Frames:
1. Extruded Aluminum: ASTM B221 (ASTM B221M), Alloy 6061-T6 or Alloy 6063-T5,
T6, or T52.
2. Color: Mill-finish.
124813-2 DEAN124813.DOC