Specifications - State of Delaware

SECTION 260529 - SUPPORTING DEVICES AND SEALS
PART 1 - GENERAL
1.01 SUMMARY:
A. This Section specifies supports, anchors, sleeves, and seals as indicated by Drawings and
schedules and/or specified in other DIVISION 26 Sections.
B. Types of supports, anchors, sleeves, and seals specified in this Section include the following:
1. Clevis hangers.
2. Riser clamps.
3. Steel rod coupling.
4. C-clamps.
5. I-beam clamps.
6. One-hole conduit straps.
7. Two-hole conduit straps.
8. Hexagonal nuts.
9. Round threaded steel rods.
10. Conduit clamps.
11. U-bolts.
12. Lead expansion anchors.
13. Toggle bolts.
14. Wall, ceiling, roof and floor seals.
15. Conduit cable supports.
16. U-channel strut system.
C. Related Work Specified Elsewhere:
1. Supports, anchors, sleeves, and seals furnished as part of factory-fabricated equipment,
are specified as part of that equipment assembly in other DIVISION 26 Sections.
1.02 REFERENCES:
A. Applicable Standards: Comply with the following standards.
1. American Society for Testing and Materials (ASTM):
a. E814 - Fire Tests of Through-Penetration Fire Stops, pertaining to fire stop
components.
2. National Fire Protection Association (NFPA):
a. 70 - National Electrical Code (NEC).
3. National Electrical Contractors Association (NECA):
a. Standard of Installation - Pertaining to anchors, fasteners, hangers, supports, and
equipment mounting.
4. Underwriters Laboratories (UL):
a. Provide electrical devices, components, and fire stops which are UL-listed and
labeled.
1.03 SUBMITTALS:
A. Refer to DIVISION 01 and SECTION 260000 - BASIC ELECTRICAL REQUIREMENTS for
administrative and procedural requirements for submittals.
B. Includes, but not limited to, the following:
1. Product Data: Submit manufacture's data on supporting devices including catalog cuts,
specifications, and installation instructions for each type of support, anchor, sleeve, and
seal.
DEAN260529.DOC 260529-1