Specifications - State of Delaware

SECTION 102226 - OPERABLE PARTITIONS: continued
Include statement indicating cost for each certified wood product including blocking,
hardwood lumber, veneer and plywood.
2. Product Data for Credit IEQ 4.4: For composite wood products, documentation
indicating that products contain no urea formaldehyde.
3. Product Data for Credit MRc4: For products containing recycled content, submit
documentation indicating percentages, by weight, of post-consumer and pre-consumer
recycled content for each product or portion of a product having recycled content.
Include statement indicating cost for each product containing recycled content material.
4. Product Data for Credit MRc5: For products and materials complying with requirements
for regional materials, submit documentation indicating location and distance from
Project of material manufacturer and point of extraction, harvest, or recovery for each
raw material. Include statement indicating cost for each regional material and the
fraction by weight that is considered regional.
5. Product Data for Credit IEQc4.1: For adhesives and sealants installed inside the
weatherproofing barrier of the building and installed on site, submit documentation
including manufacturer's printed statement (MSDS Sheet) of VOC content of each
product.
C. Shop Drawings: Include plans, elevations, sections, details, and attachments to other work.
1. For installed products indicated to comply with design loads, include structural analysis
data for attachments, signed and sealed by the qualified professional engineer responsible
for their preparation.
2. Indicate storage and operating clearances. Indicate location and installation requirements
for hardware and track, blocking, and direction of travel.
3. Wiring Diagrams: For power, signal, and control wiring.
D. Samples: For each type of exposed material, finish, covering, or facing indicated, prepared on
Samples of size indicated below:
1. Textile: Full width by not less than 36-inch long section of fabric from dye lot to be used
for the Work, with specified treatments applied. Show complete pattern repeat.
2. Panel Facing Material: Manufacturer's standard-size unit, not less than 3 inches square.
3. Panel Edge Material: Not less than 3 inches long.
4. Hardware: Manufacturer's standard exposed door-operating device.
1.06 INFORMATIONAL SUBMITTALS:
A. Coordination Drawings: Reflected ceiling plans, drawn to scale, on which the following items
are shown and coordinated with each other, based on input from installers of the items
involved:
1. Suspended ceiling components.
2. Structural members to which suspension systems will be attached.
3. Size and location of initial access modules for acoustical tile.
4. Items penetrating finished ceiling, including the following:
a. Lighting fixtures.
b. HVAC ductwork, outlets, and inlets.
c. Speakers.
d. Sprinklers.
e. Smoke detectors.
f. Access panels.
B. Setting Drawings: For embedded items and cutouts required in other work, including supportbeam,
mounting-hole template.
102226-2 DEAN102226.DOC