Electra Elite IPK Programming Manual - Southwestern Telephone ...

___________________________________________________________________________________
Document Revision 4 Electra Elite IPK
1-1-48 Access Code (3-Digit) Assignment
General Description
Use this Memory Block to assign a 3-digit number as an Access Code.
With System Software R2500, Function 001 (Station Number) can be assigned
allowing 4-digit numbers by 10s group, 5-digit numbers by 100s group, 6-digit
numbers by 1000s group, or 7-digit numbers by 10000s group.
Display
Data
No.
Programming Procedures
1 Go off-line.
Title
Third
Digit
Table
No.
(01~04)
Dial
No.
0~9
# *
4 8 : 3 D G / 0 1 ( 0 ) = 0 0 0
T I M E D I S P L A Y
2 Press LK1 + LK1 + DH to access the Memory Block.
3 Enter the Function No. for Dial No. 0 for Third Digit Table No. 01 using the dial pad.
Use the following to enter data:
�
Jto move the cursor left
Lto move the cursor right
K~Ito enter numeric data
B andJto � enter
B andLto enter #
Function
No.
4 Press G to write the data and display the next Dial No.
Default Values
5 After last Dial No. entry, press G to write the data and display Third Digit Table No. 02, Dial No. 0.
6 Enter Function No. for Dial No. 0, and press G to write the data and display the next Dial No.
All Dial 000 (Not Used)
7 After last Dial No. entry for Table 02, press G to write the data and display Third Digit Table No. 03, Dial No. 0.
8 Enter Function No. for Dial No. 0, and press G to write the data and display the next Dial No.
9 After last Dial No. entry for Table 03, press G to write the data and display Third Digit Table No. 04.
10 Enter Function No. for Dial No. 0, and press G to write the data and display the next Dial No.
11 After last Dial No. entry for Table 04, press G to write the data and display the next Memory Block.
12 Program next Memory Block or press E to go back on-line.
System Mode
1
Submode
1
Data No.
48
PC Programming
�+BA
___________________________________________________________________________________
2 - 60 Memory Blocks