Electra Elite IPK Programming Manual - Southwestern Telephone ...

Document Revision 4 Electra Elite IPK
___________________________________________________________________________________
4-18 Station Name Assignment
General Description
Use this Memory Block to assign names for telephone stations.
R4000 or higher is required to support 16 characters for the Station Name.
Display (R3500 or lower)
Tel
Port
No.
(01~C0)
Display (R4000 or higher)
Programming Procedures
1 Go off-line.
Data
No.
0 1 / 1 8 : < >
Tel
Port
No.
(01~C0)
2 Press LK4 + AH to access the Memory Block.
3 Use the dial pad to enter data.
T I M E D I S P L A Y
Data
No.
Setting
Data
Setting
Data
0 1 / 1 8 : S T A N A M E
Setting Data
Use the following to enter data:
�
Jto move the cursor left
Lto move the cursor right
K~Ito enter numeric data or Tel Port No.
– OR –
D to go to next assigned Tel Port No.
H to clear data when cursor is at setting data
B + Ato enter A for Port Numbers 100~109
B + Bto enter B for Port Numbers 110~119
B + Cto enter C for Port Number 120
4 Press G to write the data and display the next Memory Block.
5 Program the next Memory Block or press E to go back on-line.
Default Values
Not Specified
Telephone Mode
4
Submode
—
Data No.
18
PC Programming
�+BTT
___________________________________________________________________________________
2 - 528 Memory Blocks