Electra Elite IPK Programming Manual - Southwestern Telephone ...

Document Revision 4 Electra Elite IPK
___________________________________________________________________________________
3-18 Tie Line Release Detect Time
Selection
General Description
Use this Memory Block to specify the time before the circuit disconnect detected on
the Tie line on the distant system side is recognized as Tie line release.
Display
Settings
Page 1
LK 1 LK 2 LK 3 LK 4 LK 5 LK 6 LK 7 LK 8
0
Page 2
130 260 390 520 650 780 910
LK 1 LK 2 LK 3 LK 4 LK 5 LK 6 LK 7 LK 8
1040 1170 1300 1430 1560 1690 1820 1950
Programming Procedures
1 Go off-line.
CO/PBX
No.
(01~64)
Data
Setting
Page
Data
Title No.
0 1 / 1 8 : R L S 5 2 0 | 1
T I M E D I S P L A Y
2 Press LK3 + G + AH to access the Memory Block.
3 Press the corresponding CO/PBX line key to change release detect time for CO/PBX No.
Use the following to enter data:
�
Jto move the cursor left
Lto move the cursor right
K~Ito enter numeric data or CO/PBX No.
– OR –
D to go to the next assigned CO/PBX No.
C to go to the next page
A to go to the previous page
4 Press G to write the data and display the next Memory Block.
5 Program the next Memory Block or press E to go back on-line.
CO/PBX Line Mode
3
Submode
—
Data No.
18
PC Programming
�+ALM
The shaded
selection is the
default. Times
are in
milliseconds.
___________________________________________________________________________________
2 - 442 Memory Blocks