Electra Elite IPK Programming Manual - Southwestern Telephone ...

Document Revision 4 Electra Elite IPK
___________________________________________________________________________________
4-26 DISA ID Number Station Assignment
General Description
Use this Memory Block to assign the Direct Inward System Access (DISA) ID Buffer
Number corresponding to the station port number. The Station Message Detail
Recording (SMDR) printout of the station number identifies the calling party that dialed
the DISA ID number.
Display
Station
Port
No.
(01~C0)
Programming Procedures
1 Go off-line.
Data
No.
Title
0 1 / 2 6 : I D N O . = 0 1
T I M E D I S P L A Y
2 Press LK4 + BF to access the Memory Block.
3 Use the dial pad to assign DISA ID Buffer Number 01 to Station Port No.
Use the following to enter data:
�
Jto move the cursor left
Lto move the cursor right
K~Ito enter numeric data or Tel Port No.
– OR –
D to go to next assigned Tel Port No.
B + Ato enter A for Port Numbers 100~109
B + Bto enter B for Port Numbers 110~119
B + Cto enter C for Port Number 120
4 Press G to write the data and display the next Memory Block.
5 Program the next Memory Block or press E to go back on-line.
Telephone ports A0~C0 are ports 100~120.
Setting
Data
Default Values
Station Port
Number
� Notes �
Telephone Mode
4
Submode
—
Data No.
26
PC Programming
�+BD
DISA ID Buffer
Number
01 01
02 ~ C0 02 ~ C0
___________________________________________________________________________________
2 - 536 Memory Blocks