Electra Elite IPK Programming Manual - Southwestern Telephone ...

Document Revision 4 Electra Elite IPK
___________________________________________________________________________________
3-16 Tie Line Prepause Time Selection
General Description
Use this Memory Block to specify the time (prepause) before the originating side can
send dial pulse or dual-tone multifrequency (DTMF) to the distant system.
Display
Settings
Page 1
LK 1 LK 2 LK 3 LK 4 LK 5 LK 6 LK 7 LK 8
0
Page 2
0.5 1.0 1.5 2.0 3.0 4.0 5.0
LK 1 LK 2 LK 3 LK 4 LK 5 LK 6 LK 7 LK 8
6.0 7.0 8.0 9.0 10.0 11.0 12.0 13.0
Programming Procedures
1 Go off-line.
CO/PBX
No.
(01~64)
Data
No.
Title
2 Press LK3 + G + AF to access the Memory Block.
3 Press the corresponding CO/PBX line key to change prepause time for CO/PBX No.
Use the following to enter data:
�
Jto move the cursor left
Lto move the cursor right
Setting
Data
0 1 / 1 6 : P R E 0 | 1
T I M E D I S P L A Y
K~Ito enter numeric data or CO/PBX No.
– OR –
D to go to the next assigned CO/PBX No.
C to go to the next page
A to go to the previous page
4 Press G to write the data and display the next Memory Block.
5 Program the next Memory Block or press E to go back on-line.
1. Prepause time differs according to the acknowledgment signaling method.
Page
No.
� Notes �
2. This Memory Block affects T1 channels assigned as Tie/DID lines.
CO/PBX Line Mode
3
Submode
—
Data No.
16
PC Programming
�+ALM
The shaded
selection is the
default. Times
are in seconds.
___________________________________________________________________________________
2 - 440 Memory Blocks