Electra Elite IPK Programming Manual - Southwestern Telephone ...

___________________________________________________________________________________
Document Revision 4 Electra Elite IPK
1-1-66 8-Digit Matching Table to Normal
Dial Assignment
General Description
Use this Memory Block to assign the 8-Digit Matching Table by class for normal dialing
as used or unused. When unused is assigned, the system does not check during
normal dialing even when Memory Block 1-1-61 (8-Digit Matching Table to Class
Assignment) is programmed.
Display
Settings
Page 1
LK 1 LK 2 LK 3 LK 4 LK 5 LK 6 LK 7 LK 8
Table 00 Table 01 Table 02 Table 03 Table 04 Table 05 Table 06 Table 07
LK 1 LK 2 LK 3 LK 4 LK 5 LK 6 LK 7 LK 8
Table 08 Table 09 Table 10 Table 11 Table 12 Table 13 Table 14 Table 15
Programming Procedures
1 Go off-line.
Related Programming
Data
Title
No.
6 6 : N O R M A L D I A L | 1
T I M E D I S P L A Y
2 Press LK1 + LK1 + FF to access the Memory Block.
3 Press the corresponding CO/PBX line key to change data option for each Table.
Use the following to enter data:
�
C to access the next page
A to access the previous page
Each time a CO/PBX line key is pressed, the LED toggles between On
�
and Off.
CO/PBX Line LED Off On
Refer to Chapter 3 Advanced Applications, Section 1 Code Restriction on page 3-1.
Page
No.
Data Restricted Not restricted
4 Press G to write the data and display the next Memory Block.
5 Program the next Memory Block or press E to go back on-line.
The shaded
selection is
the default.
Default Values
The shaded
selection is the
default.
System Mode
1
Submode
1
Data No.
66
PC Programming
�+AC
Tables 00~14 Used (Non-OCC and OCC)
Table 15 Unused (OCC calls only)
___________________________________________________________________________________
2 - 86 Memory Blocks