Electra Elite IPK Programming Manual - Southwestern Telephone ...

Document Revision 4 Electra Elite IPK
___________________________________________________________________________________
3.7.9 Local Operator Call – Dial 9 +0
LCR search sequence: Dial 0 of International/Operator Table 1→
RAB 09→ TG 02 → CO 23.
SETUP Message
CPN NSF
RAB TN NPI TNI NIP NID
3.8 Service Conditions
The following service conditions apply.
� The Electra Elite supports the AT&T 5ESS-2000 switch, Software
release 5E12 or later using the National ISDN PRI version only.
Caller ID is displayed as with normal CO calls.
�
LCR is necessary for Call by Call origination.
�
� For an outgoing call to an external line, dialed digits are sent collectively
when the specified ISDN interdigit dialing interval (MB 1-1-81, ISDN/
K-CCIS Interval Time Selection, 4 sec default) from the last digit expires.
When a digit is not dialed after seizure of the external line before the
interdigit interval times out, the external line is released and a Busy Tone
is generated.
� When Call forward Off-premise is assigned, MB 4-47 (ISDN Directory
Number Selection) follows the specification at the TEL to which the call
is forwarded.
No tandem connection is allowed in Tie Trunk Mode.
�
For PRI trunks, CO or DID type should be assigned using MB 3-91
�
(Trunk Type Selection).
� When PRT is used as an outgoing trunk on Automatic Trunk-to-Trunk
transfer, Caller ID follows the MB 3-52 (ISDN Trunk Directory Number
selection) setting. When allowed, Caller ID is sent to the network.
For an incoming call, the lowest numbered channel in the PRT trunk is
�
used.
� Call by Call does not follow Tenant Day/Night Mode switching.
___________________________________________________________________________________
3 - 48 Advanced Applications
F/S
FCV
09 0(U) 0(U) No Digits None None None S MEGACOM
Service FCV Feature FCV
Operator
(Local)
Service
Parameter
None