Electra Elite IPK Programming Manual - Southwestern Telephone ...

___________________________________________________________________________________
Document Revision 4 Electra Elite IPK
1-14-02 ARS Dial Allow/Deny Selection
General Description
Use this Memory Block to specify whether or not to Allow digits that are entered in the
ARS dialing assignment to be routed using the ARS feature.
Display
Settings
Data
No.
LK 1 LK 2 LK 3 LK 4 LK 5 LK 6 LK 7 LK 8 The shaded
selection is the
YES NO
default.
Programming Procedures
1 Go off-line.
Table
No.
1~4
2 Press LK1 + LK14 + KB to access the Memory Block.
3 Press the corresponding CO/PBX line key to change the Setting Data option.
Use the following to enter data:
�
K~Ito select data
Jto move cursor left
Lto move cursor right
4 Press G to write the data. The next Dial No. is displayed.
5 Repeat Steps 3 and 4 for each Dial No. (01~C8) for Table 1. After Dial No. C8 is programmed, the next Table No. is displayed.
6 Repeat Programming cycle for each Dial No.(01~C8) for Tables 2~4. The next Memory Block is displayed.
7 Program the next Memory Block or press E to go back on-line.
Related Programming
Dial
Title
No.
0 2 : 1 / 0 1 A / D Y E S
T I M E D I S P L A Y
M.B. Number Memory Block Name
3-03 Trunk-to-Trunk Group Assignment
4-40 LCR Class Selection
1-1-30 Route Advance Block Assignment
1-8-08 Class of Service (Station) Feature Selection 2
1-14-00 ARS Allow/Deny Selection
1-14-01 ARS Dialing Assignment
Setting
Data
System Mode
1
Submode
14
Data No.
02
PC Programming
�+AB
___________________________________________________________________________________
2 - 320 Memory Blocks