Electra Elite IPK Programming Manual - Southwestern Telephone ...

Electra Elite IPK Document Revision 4
___________________________________________________________________________________
Programming Procedures (Continued)
5 Repeat Steps 3 and 4 for each Line Key assignment. After Line Key No. 24 is programmed, the next Memory Block is displayed.
6 Program the next Memory Block or press E to go back on-line.
Related Programming
M.B. Number Memory Block Name
2-05 Line Key Selection (Tenant Mode)
1. When an Electra Elite IPK system is installed as a Key Function (KF) system, all COs must be assigned to the
line keys. Trunk groups, Route Advance Blocks and Least Cost Routing (LCR) cannot be assigned.
� Notes �
2. At system default, line keys 09~24 are not assigned.
3. Telephone ports A0~C0 are ports 100~120.
4. A minimum of two call appearance keys should be assigned to each PS II.
___________________________________________________________________________________
Programming Manual 2 - 519