Electra Elite IPK Programming Manual - Southwestern Telephone ...

Electra Elite IPK Document Revision 4
___________________________________________________________________________________
3-44 Caller ID Display Assignment for CO/
PBX Line
General Description
Use this Memory Block to assign one Multiline Terminal to display ANI/Caller ID
Indication for incoming CO/PBX calls per CO/PBX line.
This Memory Block is used for R1600 and lower. For R1700 or higher, it is no longer
required.
Display
CO/PBX
No.
(01~64)
Programming Procedures
1 Go off-line.
2 Press LK3 + G + DDto access the Memory Block.
3 Enter data for CO/PBX No. using the dial pad to assign ANI/Caller ID to a station.
Use the following to enter data:
�
Jto moves the cursor left
Related Programming
Data
No.
Title
0 1 / 4 4 : C A L L I D
T I M E D I S P L A Y
Lto moves the cursor right
Tel
No. Port
01~C0
K~Ito enter numeric data or CO/PBX No.
– OR –
D to go to the next assigned CO/PBX Line No.
Enter the following:
�
Tel Port No. 01~CO
CO/PBX No. 01~64
4 Press G to write the data and display the next Memory Block.
5 Program the next Memory Block or press E to go back on-line.
Refer to individual features in the Electra Elite IPK Features and Specifications Manual.
Default Values
No Assignment
CO/PBX Line Mode
3
Submode
—
Data No.
44
PC Programming
�+AI
___________________________________________________________________________________
Programming Manual 2 - 475