Electra Elite IPK Programming Manual - Southwestern Telephone ...

Document Revision 4 Electra Elite IPK
___________________________________________________________________________________
4-67 IP Station Number Assignment
General Description
Use this Memory Block to assign a station number for each IP telephone supported by
the IPCA( )-U( ) ETU.
System Software R2500 is required.
Display
Port Tel
No.
(01~CO)
Programming Procedures
1 Go off-line.
Data
Title
No.
0 1 / 6 7 : I P I C M
Setting
Data
T I M E D I S P L A Y
2 Press LK4 + FG to access the Memory Block.
� 3 Use dial pad to assign a 2- (10~89), 3- (100~899) or 4-digit (1000~8999) station number for each Tel Port No.:
Jto move the cursor left
Lto move the cursor right
K~Ito enter numeric data or Tel Port No.
– OR –
D to go to next assigned Tel Port No.
B + Ato enter A for Port Numbers 100~109
B + Bto enter B for Port Numbers 110~119
B + Cto enter C for Port Number 120
4 Press G to write the data and display the next Memory Block.
5 Program the next Memory Block or press E to go back on-line.
CO/PBX Line Mode
4
Submode
—
Data No.
67
PC Programming
�+BTT
___________________________________________________________________________________
2 - 588 Memory Blocks