Electra Elite IPK Programming Manual - Southwestern Telephone ...

Document Revision 4 Electra Elite IPK
___________________________________________________________________________________
Programming Procedures (Continued)
3 Press the CO/PBX line key to select a function for Line Key No. 1, and use dial
keys to enter Setting Data 2 if required.
Use the following to enter data:
�
Jto move the cursor left
Lto move the cursor right
K~Ito enter numeric data or Tel Port No.
– OR –
D to go to next assigned Tel Port No.
C to go to the next page, or + to switch to page 2
A to go to the previous page, or = to switch to page 1
B + Ato enter A for Port Numbers 100~109
B + Bto enter B for Port Numbers 110~119
B + Cto enter C for Port Number 120
For example, to assign Trunk Group 5 to CO/PBX line key 1, press LK7 to
display the TKGP, and enter 05 using the dial pad.
Setting Data Page 1
Line
Key
Functions
[For each telephone in tenant specified as
Telephone Mode in Memory Block 2-05 (Line
Key Selection)]
4 Press G to write the data and display the next Line Key No.
Setting Data 1
LCD Indication
1 Not Specified NON N/A
Default Values
2 CO/PBX line CO 01~64
3 Call Forward – Busy/No Answer FW BNA N/A
4 Call Forward – All Call FW ALL N/A
5 Call Appearance Block C00~C47
(Call Appearance Block)
6 Feature Access F A 01~16
7 Trunk Group TKGP 01~32
8 Route Advance ADV 01~32
Setting Data Page 2
1
Secondary Incoming Extension, including CAR SIE
2 Microphone MIC N/A
3 Headset H SET N/A
4 Scroll Key for ANI/Caller ID SCROLL N/A
5 Do Not Disturb - Break Mode On/Off DND N/A
6 Log On/Off LOG N/A
7 Background Music On/Off BGM N/A
8 Intercom Key ICM N/A
For Tel 01~CO: LK01~08 Assigned to
CO/PBX lines 01~08.
Setting Data 2
01~24
(Call Appearance Key)
Telephone Port No.
01~99, A0~C0
___________________________________________________________________________________
2 - 518 Memory Blocks