Electra Elite IPK Programming Manual - Southwestern Telephone ...

___________________________________________________________________________________
Document Revision 4 Electra Elite IPK
1-15-11 Centralized Billing Allow/Deny
Selection
General Description
Use this Memory Block to assign the Electra Elite IPK to send billing to the Billing
Center Office (NEAX2000/2400) across the K-CCIS network. Electra Elite IPK does
not support receiving and managing billing information.
Display
Settings
LK 1 LK 2 LK 3 LK 4 LK 5 LK 6 LK 7 LK 8 The shaded
Deny
NO
Data
No.
Allow
YS
Programming Procedures
1 Go off-line.
2 Press LK1 + LK15 + A Ato access the Memory Block.
3 Press the corresponding CO/PBX line key to change the Setting Data option.
4 Press G to write the data.
5 Press E to go back on-line.
Related Programming
Title
1 1 : B I L L I N G N O
T I M E D I S P L A Y
M.B. Number Memory Block Name
7-1 Card Interface Slot Assignment
7-3-01 MIF (LCR) Assignment
7-3-02 MIF (SMDR) Assignment
1-15-00 K-CCIS Main/Remote Office Selection
1-15-01 Common Signal Channel Data Speed Assignment
1-15-02 Common Signal Channel Assignment
1-15-03 Originating Point Code Assignment
1-15-04 Destination Point Code Assignment
Setting
Data
1-15-05 Destination Point Code Transfer Assignment
selection is the
default.
System Mode
1
Submode
15
Data No.
11
PC Programming
�+AW
___________________________________________________________________________________
2 - 356 Memory Blocks