Electra Elite IPK Programming Manual - Southwestern Telephone ...

___________________________________________________________________________________
Electra Elite IPK Document Revision 4
1-16-07 High Priority RX Tag Threshold
General Description
The HUB(8) has two queues: High Priority and Low Priority. When Memory Block
1-16-06 is set to NO, and the priority of the VLAN tag is equal to or greater than the
setting in this block, the tag is queued for high priority. Otherwise, it is queued for low
priority. When it is transmitted out the egress port of the HUB(8), it retains its original
VLAN tag priority value.
R1500 or higher is required.
Display
Programming Procedures
1 Go off-line.
Data
No.
HUB
1~3
PORT
1~8
2 Press LK1 + LK16 + JJKG to access the Memory Block.
3 Use dial pad keys to enter Setting data.
Use the following to enter data:
�
Use Jto move cursor left
Use Lto move cursor right
Use K~ Ito enter numeric data
Priority range is lowest 0~7 highest.
�
4 Press G to write the data.
5 Repeat steps 3 and 4 for each HUB(8)-U( ) ETU port.
6 Press E to go back on-line.
Title
0 7 : 1 - 1 H I G H R X = 7
T I M E D I S P L A Y
Setting
Data
Default Values:
All ports = 7
System Mode
1
Submode
16
Data No.
07
PC Programming
�+AB
___________________________________________________________________________________
Programming Manual 2 - 393