Electra Elite IPK Programming Manual - Southwestern Telephone ...

Document Revision 4 Electra Elite IPK
___________________________________________________________________________________
Port 8 �
Ethernet Switch that has IEEE 802.1q/p support enabled and is configured
to carry traffic for both VLAN 100 and VLAN 200.
Port 1 �
In IP terminal programming, the IP terminal is configured for priority 5, and
the PC is configured for priority 0.
Port 2 �
Not Used.
Figure 3-5 Port Priority Settings
Depicts Memory Blocks
Settings:
1-16-06 Port Based
Priority Selection
1-16-07 High Priority
RX Tag
1-16-08 High Priority
TX Tag
1-16-09 Low Priority TX
Tag
Port 3 �
The PC does not support VLAN tagging, so port-based priority could be
used.
Port 4 �
Traffic from the MG(8) is set for High Priority queue in MB 1-16-06.
Port 5 �
In IP terminal programming, the IP terminal is configured for priority 5.
Port 6 �
Traffic from the IPC is set for High Priority queue in MB 1-16-06.
Port 7 �
In IP terminal programming, the IP terminal is configured for priority 5.
___________________________________________________________________________________
3 - 60 Advanced Applications