Electra Elite IPK Programming Manual - Southwestern Telephone ...

___________________________________________________________________________________
Electra Elite IPK Document Revision 4
1-15-01 Common Signal Channel Data Speed
Assignment
General Description
Use this Memory Block to assign the Data Transmission speed for each Common
Signaling channel.
DisplayS
Settings
LK 1 LK 2 LK 3 LK 4 LK 5 LK 6 LK 7 LK 8 The shaded
selection is the
64k 56k 48k(1) 48k(2)
default.
Programming Procedures
1 Go off-line.
Data
No.
Title
2 Press LK1 + LK15 + KAto access the Memory Block.
3 Press the corresponding CO/PBX line key to change the Setting Data option.
Two adaptation rates are available with the 48 Kbps data transmission.
�
The adaptation method must match the rate adaptation of the clock source
office.
Data format for 48k(1) is as follows:
Data format for 48k(2) is as follows:
4 Press G to write the data.
5 Press E to go back on-line.
Setting
Data
0 1 : C C H 1 = 5 6 k
T I M E D I S P L A Y
1 1
1
Data
Data
1
System Mode
1
Submode
15
Data No.
01
PC Programming
�+AW
___________________________________________________________________________________
Programming Manual 2 - 335