Electra Elite IPK Programming Manual - Southwestern Telephone ...

Document Revision 4 Electra Elite IPK
___________________________________________________________________________________
3-14 Tie Line Type Assignment
General Description
Use this Memory Block to assign the loop supervision to be used for each Trunk
associated with a Tie line.
Display
Settings
LK 1 LK 2 LK 3 LK 4 LK 5 LK 6 LK 7 LK 8 The shaded
selection is the
2ND DIAL IMMEDIATE DELAY WINK
default.
Programming Procedures
1 Go off-line.
Tie/DID
No.
(01~64)
2 Press LK3 + G + ADto access the Memory Block.
3 Press the corresponding CO/PBX line key to change the loop supervision for CO/PBX No.
Use the following to enter data:
�
Jto move the cursor left
Lto move the cursor right
K~Ito enter numeric data or CO/PBX No.
– OR –
D to go to the next assigned CO/PBX No.
4 Press G to write the data and display the next Memory Block.
5 Program the next Memory Block or press E to go back on-line.
Related Programming
Data
Title
No.
0 1 / 1 4 : 2 N D D I A L
T I M E D I S P L A Y
M.B. Number Memory Block Name
3-92 Trunk (Installed, DP/DTMF) Selection
CO/PBX Line Mode
3
Submode
—
Data No.
14
PC Programming
�+ALT
___________________________________________________________________________________
2 - 436 Memory Blocks