Electra Elite IPK Programming Manual - Southwestern Telephone ...

___________________________________________________________________________________
Electra Elite IPK Document Revision 4
LK 1 System Mode
Data
No.
LK 1 CO Line (Continued)
Memory Block Name Default Value Programming Values
35 Speed Dial Buffer Allocation 100 100, 1,000 Memories
37 Trunk Queuing Timeout Selection 10s (R2500 or lower)
10s (R3000 or
higher)
10s, 20s, 30s, 60s (R2500 or lower)
00s (No Limit), 01s~99s (R3000 or
higher)
46 Access Code (1-Digit) Assignment Refer to 1-1-46 Access Code (1-Digit) Assignment on page
2-51.
47 Access Code (2-Digit) Assignment Refer to 1-1-47 Access Code (2-Digit) Assignment on page
2-58.
48 Access Code (3-Digit) Assignment All Dial 000
(Not Used)
49 Networking Trunk Group/Route
Advance Assignment
50 CO/PBX Outgoing Digit Add
Assignment
___________________________________________________________________________________
Programming Manual 1 - 15
N/A
Not Specified 101~132 (Trunk Group 01 ~ 32) or
201~216 (Route Advance Block
01 ~ 16)
Not Specified 10 digits max.
51 CO Line Ringing Pattern Selection A26 A ~ H, NO
52 PBX Line Ringing Pattern Selection B A ~ H, NO
53 Tie Line Delay Ring Pattern
Selection
54 Automated Attendant Transfer Ring
Pattern
D A ~ H, NO
C A ~ H, NO
55 DID Line Ringing Pattern Selection A A ~ H, NO
57 CO/PBX Prepause Time Selection 1s None, 1s~13s
59 Synchronous Ringing Selection YS YS, NO
60 8-Digit Matching Table Assignment Refer to 1-1-60 8-Digit Matching Table Assignment on page
2-78.
61 8-Digit Matching Table to Class
Assignment
62 System Speed Dial Override by
Class Selection
Refer to 1-1-61 8-Digit Matching Table to Class Assignment on
page 2-80.
YS NO = No Override
YS = Override