Electra Elite IPK Programming Manual - Southwestern Telephone ...

___________________________________________________________________________________
Electra Elite IPK Document Revision 4
1-1-01 DP Interdigit Time Selection
General Description
The DP Interdigit Time is the minimum pause time between Dial Pulses. Use this
Memory Block to Select Pattern A or Pattern B.
Display
Settings
LK 1 LK 2 LK 3 LK 4 LK 5 LK 6 LK7 LK8 The shaded
selection is the
A B
default.
Programming Procedures
1 Go off-line.
2 Press LK1 + LK1 +KAto access the Memory Block.
3 Press the corresponding CO/PBX line key to change the data option.
Data
Data
No.
4 Press G to write the data and display the next Memory Block.
5 Program the next Memory Block or press E to go back on-line.
Related Programming
0 1 : D P I N T E R B
DP Dial
Title
T I M E D I S P L A Y
M.B. Number Memory Block Name
10 pps 20 pps
Pattern A 650 ms. 500 ms.
Pattern B 800 ms. 800 ms.
3-92 Trunk (Installed, DP/DTMF) Selection
Data
Setting
Dial
Signal
Minimum
Pause
Time
Use this Memory Block when DP Tie lines or DID are assigned in Memory Block 3-92 [Trunk (Installed, DP/
DTMF) Selection] to send Dial Pulse signaling.
� Notes �
System Mode
1
Submode
1
Data No.
01
PC Programming
�+BCM
Dial
Signal
___________________________________________________________________________________
Programming Manual 2 - 3