Electra Elite IPK Programming Manual - Southwestern Telephone ...

___________________________________________________________________________________
Electra Elite IPK Document Revision 4
1-16-08 High Priority TX Tag Assignment
General Description
For frames marked at the ingress port by Memory Block 1-16-06 as High Priority, this
memory block setting on the egress port assigns a value (0 ~7) to the priority field of
the VLAN tag. The default is 7.
R1500 or higher is required.
Display
Programming Procedures
1 Go off-line.
Data
No.
HUB
1~3
PORT
1~8
2 Press LK1 + LK16 + JJKH to access the Memory Block.
3 Use dial pad keys to enter Setting data.
Use the following to enter data:
�
Use Jto move cursor left
Use Lto move cursor right
Use K~ Ito enter numeric data
Priority range is lowest 0~7 highest.
�
4 Press G to write the data.
5 Repeat steps 3 and 4 for each port.
6 Press E to go back on-line.
Title
0 8 : 1 - 1 H I G H T X = 7
T I M E D I S P L A Y
Setting
Data
Default Values:
All ports = 7
System Mode
1
Submode
16
Data No.
08
PC Programming
�+AB
___________________________________________________________________________________
Programming Manual 2 - 395