Electra Elite IPK Programming Manual - Southwestern Telephone ...

Document Revision 4 Electra Elite IPK
___________________________________________________________________________________
3.3.6 Route Advance Block Assignment (Memory Block 1-1-30)
Use this Memory Block to assign priority levels to each Trunk Group
assigned in a Route Advance Block.
Default: All Blocks 00
3.3.7 ISDN DTMF Duration/Interdigit Selection (Memory Block 1-1-80)
Use this Memory Block to specify tone duration and interdigit time of
DTMF signals for ISDN trunks.
Default: 100/70 milliseconds
3.3.8 ISDN / K-CCIS Interval Time Selection (Memory Block 1-1-81)
Use this Memory Block to specify time between digits dialed.
Default: 4s
3.3.9 SLT or Automated Attendant/DISA to CPU PBR Selection (Memory
Block 1-8-01)
Use this Memory Block to specify whether the PBR circuits in the
CPU are for Single Line Telephones or Automated Attendant/DISA.
Default: SLT
3.3.10 PBR Receive Level Assignment for Automated Attendant/DISA
(Memory Block 1-8-02)
Use this Memory Block to Specify the receiving level at the
Automated Attendant /DISA.
Default: 03 (-36 dBm)
3.3.11 Master Clock Selection (Memory Block 1-8-33)
Use this Memory Block to assign the source for synchronization of
the clocking for DTI-U( ), PRT(1)-U( ), or BRT(4)-U( ) ETU.
Default: 0 (Not assigned)
3.3.12 Trunk to Tenant Assignment (Memory Block 2-01)
Use this Memory Block to assign CO/PBX lines to tenants.
Default: CO/PBX lines 01~64 are assigned
3.3.13 Line Key Selection (Memory Block 2-05)
Use this Memory Block to select Tenant mode or Telephone Mode
line key assignment for each tenant.
Default: TEL
___________________________________________________________________________________
3 - 34 Advanced Applications