Electra Elite IPK Programming Manual - Southwestern Telephone ...

Document Revision 4 Electra Elite IPK
___________________________________________________________________________________
Programming Procedures
1 Go off-line.
2 Press LK2 to access the Memory Block.
3 Press the corresponding CO/PBX line key to change the data option.
Use the following to enter data:
�
Jto move the cursor left
Lto move the cursor right
K~Ito enter numeric data
D to go to the next assigned Tenant No.
C to go to the next page
A to go to the previous page
� Data Options:
4 Press G to write the data. The next Memory Block is displayed.
5 Program Memory Blocks 2-05~2-09. The next Tenant No. is displayed.
Default Values
6 Repeat steps 3, 4, and 5 for each Tenant No. Memory Block 2-01 Tenant 00 is displayed.
7 Press E to go back on-line.
Related Programming
\
CO/PBX
Line LED
Data
M.B. Number Memory Block Name
2-05 Line Key Selection
Off On
No
(Not Assigned)
4-09 Telephone to Tenant Assignment
Yes
(Assigned)
Tenant 00 = All trunks are assigned
Tenant 01~47 = Not assigned
When data is changed while the system is busy, DATA ENTRY is displayed at the programming station until the
system becomes idle.
� Notes �
___________________________________________________________________________________
2 - 416 Memory Blocks