Electra Elite IPK Programming Manual - Southwestern Telephone ...

___________________________________________________________________________________
Electra Elite IPK Document Revision 4
1-10-07 Call by Call Service Parameter
Assignment
General Description
Use this Memory Block to specify the Service Parameters for each Route Advance
Block (RAB). This setting data is sent to the Service Parameters in the NSF-IE
(Network Specific Facility Code-Information Element) when making outgoing calls.
Service Parameter Assignment is an Identification Number that is assigned when
subscribing with the carrier for the different services.
Display
RAB
01~32
Programming Procedures
1 Go off-line.
Data
No.
Title
1~5
Setting
1 Data
0 1 / 0 7 : S P 1 = 0 – 0 0 0
T I M E D I S P L A Y
2 Press LK1 + LK10 + JG to access the Memory Block.
3 Enter 1~5 digits for Setting Data using the dial pad.
Use the following to enter data:
�
JandLto move the cursor
K~Ito enter data
D to select next RAB No.
Setting
2 Data
Setting Data No. 1 = 0 or 1 for each entry.
�
Setting Data No. 2 = Three-digit code 000~127 for each entry.
�
4 Press G to write the data. Digit 2 is displayed.
Default Values
All RABs 0~000
5 Repeat Steps 3 and 4 for each remaining digit for RAB 1. The next Memory Block is displayed.
6 Program the next Memory Block or press E to go back on-line.
System Mode
1
Submode
10
Data No.
07
PC Programming
�+AY
___________________________________________________________________________________
Programming Manual 2 - 277