Electra Elite IPK Programming Manual - Southwestern Telephone ...

Document Revision 4 Electra Elite IPK
___________________________________________________________________________________
3-06 Automatic Tandem Trunk Assignment
Use this Memory Block to specify the incoming trunk and outgoing trunk for Automatic
Trunk-to-Trunk Transfer.
Display
Programming Procedures
1 Go off-line.
(Incoming)
CO/PBX
No.
(01~64)
2 Press LK3 + G + KFto access the Memory Block.
3 Enter the outgoing trunk number for incoming CO/PBX No.
Use the following to enter data:
�
Jto move the cursor left
Lto move the cursor right
K~Ito enter numeric data or CO/PBX No.
– OR –
D to go to the next assigned CO/PBX No.
4 Press G to write the data and display the next Memory Block.
5 Program the next Memory Block or press E to go back on-line.
Related Programming
Data
No.
Title
0 1 / 0 6 : T A N D C O =
T I M E D I S P L A Y
M.B. Number Memory Block Name
Setting
Data
3-04 Trunk-to-Trunk Transfer Yes/No Selection
3-05 Trunk Incoming Answer Mode Selection
Default Values
Not Specified
CO/PBX Line Mode
3
Submode
—
Data No.
06
PC Programming
�+AT
___________________________________________________________________________________
2 - 432 Memory Blocks