Electra Elite IPK Programming Manual - Southwestern Telephone ...

___________________________________________________________________________________
Electra Elite IPK Document Revision 4
1-16-00 Auto Negotiation Yes/No Selection
General Description
Use this Memory Block to specify whether or not Auto Negotiation is enabled for each
port of the HUB(8)-U( ) ETU. When No is selected, Memory Block 1-16-01 (Port
Speed Selection 10/100 Base -T) and Memory Block 1-16-02 (Port Duplex Mode
Selection) are used. When equipment with auto negotiation function is connected to a
port, ensure that the YS is set for this Memory Block.
R1500 or higher is required.
Display
Settings
LK 1 LK 2 LK 3 LK 4 LK 5 LK 6 LK 7 LK 8 The shaded
selection is the
YS NO
default.
Programming Procedures
1 Go off-line.
Data
No.
HUB
1~3
PORT
1~8
2 Press LK1 + LK16 to access the Memory Block.
3 Press the corresponding CO/PBX line key to change the Setting Data option.
4 Press G to write the data.
5 Repeat steps 3 and 4 for each Port.
6 Press E to go back on-line.
Title
0 0 : 1 - 1 A U T O Y S
T I M E D I S P L A Y
Setting
Data
System Mode
1
Submode
16
Data No.
00
PC Programming
�+AB
___________________________________________________________________________________
Programming Manual 2 - 379