Electra Elite IPK Programming Manual - Southwestern Telephone ...

Document Revision 4 Electra Elite IPK
___________________________________________________________________________________
4-68 LCD Line Key – Name Assignment
General Description
Use this Memory Block to assign a name to each LCD Line Key of the
DTH/DTR-16LD-1 Telephone. Up to eight characters can be assigned.
Display
Port Tel
(01~CO)
Programming Procedures
1 Go off-line.
2 Press LK4 + FH to access the Memory Block.
3 Use the dial pad to change Line key number or name.
Use the following to enter data:
�
Jto move the cursor left
Lto move the cursor right
K~Ito enter Name, Line key number or Tel Port No.
– OR –
D to go to next assigned Tel Port No.
B + Ato enter A for Port Numbers 100~109
B + Bto enter B for Port Numbers 110~119
B + Cto enter C for Port Number 120
4 Press G to write the data and display the next Line key and name.
Default Value
LK01~08: C0 01~08
5 Repeat Steps 3 and 4 for each Line key assignment. After Line key 16 is programmed, the next Tel Port No. is displayed. When
you want to program less than 16 keys, after the last Line key to program, press D to go to next assigned Tel Port No.
After all Tel Ports are assigned, the next Memory Block is displayed.
6 Program the next Memory Block or press E to go back on-line.
Related Programming
Data
No.
0 1 / 6 8 : L K 0 1 N A M E
Setting Data
< C O 0 1 >
M.B. Number Memory Block Name
Key Line
Title
01~16
7-2 Telephone Type Assignment
4-12 Line Key Selection for Telephone Mode
CO/PBX Line Mode
4
Submode
—
Data No.
68
PC Programming
�+BTT
___________________________________________________________________________________
2 - 590 Memory Blocks