Electra Elite IPK Programming Manual - Southwestern Telephone ...

Electra Elite IPK Document Revision 4
___________________________________________________________________________________
7-2 Telephone Type Assignment
General Description
Use this Memory Block to specify the device that is connected to an ESI port.
Display
Settings
ESI
No. Port
(01~CO)
LK 1 LK 2 LK 3 LK 4 LK 5 LK 6 LK 7 LK 8 The shaded
NON TEL CONSOL SLT ADP
Programming Procedures
1 Go off-line.
0 1 : T E L
Related Programming
Setting
Data
T I M E D I S P L A Y
2 Press LK7 + LK2 to access the Memory Block.
3 To change data, press the corresponding CO/PBX line key.
Use the following to enter data:
�
D to go to next assigned ESl Port No. or cycle back to 1.
4 Press G to write the data.
5 Press E to go back on-line.
DIGITAL
VM
Refer to individual features in the Electra Elite IPK Features and Specifications Manual.
1. Only Multiline Terminals can be assigned to ports 01 and 02.
MSG
BOARD
� Notes �
2. A maximum of four Attendant Add-On Consoles can be installed in the system.
3. A maximum of eight SLT(1)-U( ) ADP adapters can be installed in the system.
4. A maximum of 32 Digital Voice Mail ports are available.
selection is the
default.
5. When assigning SLT adapters or Digital Voice Mail ports, Memory Block 4-10 (Station Number Assignment) must
be reassigned also.
6. The D term Cordless II, D term Cordless Lite, or D term Cordless Handset Terminal uses TEL selection.
7. A maximum of eight basic Message Display Boards and 40 expansion boards are available.
ETU Mode
7
Telephone
2
Data No.
—
PC Programming
�+BS
___________________________________________________________________________________
Programming Manual 2 - 635