Electra Elite IPK Programming Manual - Southwestern Telephone ...

___________________________________________________________________________________
Electra Elite IPK Document Revision 4
1-1-52 PBX Line Ringing Pattern Selection
General Description
Use this Memory Block to assign the initial ringing pattern or no ring for incoming calls
on a PBX line.
Display
Page 1
Data
No.
LK 1 LK 2 LK 3 LK 4 LK 5 LK 6 LK 7 LK 8
A
Page 2
B C D E F G H
LK 9
NO
LK 10 LK 11 LK 12 LK 13 LK 14 LK 15 LK 16
Programming Procedures
1 Go off-line.
Title
5 2 : P B X P T N B | 1
T I M E D I S P L A Y
Setting
Data Page
No.
2 Press LK1 + LK1 + EBto access the Memory Block.
3 Press corresponding CO/PBX line key to change data.
Use the following to enter data:
�
C to access the next page
A to access the previous page
4 Press G to write data and display the next Memory Block.
5 Program the next Memory Block or press E to go back on-line.
� Notes �
System Mode
1
Submode
1
Data No.
52
PC Programming
�+BCS
The shaded
selection is the
default.
Do not program this Memory Block if Memory Block 1-1-59 (Synchronous Ringing Selection) is assigned YS.
___________________________________________________________________________________
Programming Manual 2 - 69