Electra Elite IPK Programming Manual - Southwestern Telephone ...

Document Revision 4 Electra Elite IPK
___________________________________________________________________________________
Programming Procedures
3 Press the Line Key corresponding to ringing required for Tel Port No.
The LED indication changes to indicate data each time a CO/PBX Line Key is
pressed.
CO/PBX
Line Key LED
Data No ring
Use the following to enter data:
�
Jto move the cursor left
Lto move the cursor right
K~Ito enter numeric data or Tel Port No.
– OR –
D to go to next assigned Tel Port No.
C to go to the next page
A to go to the previous page
B + Ato enter A for Port Numbers 100~109
B + Bto enter B for Port Numbers 110~119
B + Cto enter C for Port Number 120
4 Press G to write the data and display the next Memory Block.
5 Program the next Memory Block or press E to go back on-line.
.
Related Programming
M.B. Number Memory Block Name
Off Green Red
Immediate
Ring
1-2-26 Delayed Ringing Time Assignment (ICM)
4-12 Line Key Selection for Telephone Mode
1. When Immediate Ring is set, the LED is green.
Default Values
All Telephones: No Ring
� Notes �
2. This Memory Block applies only when an SIE or Call Arrival key is programmed for line key appearance.
3. Telephone ports A0~C0 are ports 100~120.
Delayed
Ring
The shaded
selection is the
default.
___________________________________________________________________________________
2 - 548 Memory Blocks