Electra Elite IPK Programming Manual - Southwestern Telephone ...

Document Revision 4 Electra Elite IPK
___________________________________________________________________________________
4-70 LCD Line Key – Name Assignment
(Station Add-On Console)
General Description
Use this Memory Block to assign a name to each Station Add-On Console. Up to
eight characters can be assigned per line key.
R4000 or higher is required to support the Add-On Console.
Display
Port Tel
No.
(01~CO)
Programming Procedures
1 Go off-line.
Data
No.
0 1 / 7 0 : D S 0 1 N A M E 5
< >
Setting Data
No LK
Name
01~16
2 Press LK4 + GK to access the Memory Block.
3 Use the dial pad to change line key number or name.
� Use the following to enter data:
to move the cursor left
L to move the cursor right
J
K~Ito enter numeric data or Tel Port No.
– OR –
D to go to next assigned Tel Port No.
B + Ato enter A for Port Numbers 100~109
B + Bto enter B for Port Numbers 110~11
B + Cto enter C for Port Number 120
4 Use dial pad to enter characters for each line key.
5 Press G to write the data and display the next line key and name.
6 Repeat step 4 for each line key assignment. After Line Key 16 is programmed, the
next Memory Block is displayed. For less than 16 line keys, after the last line key
to be programmed, press D to go to next Tel. Port No.
7 Program the next Memory Block or press E to go back on-line.
Default Value
LK01~16: Blank
CO/PBX Line Mode
4
Submode
—
Data No.
70
PC Programming
�+BTM
___________________________________________________________________________________
2 - 594 Memory Blocks