Electra Elite IPK Programming Manual - Southwestern Telephone ...

___________________________________________________________________________________
Electra Elite IPK Document Revision 4
1-13-04 PRT B Channel Outgoing Priority
Selection
General Description
Use this Memory Block to assign the Outgoing Priority for the B-channels when calls
are originated on a PRT(1)-U( ) ETU.
This assignment is allowed by handset programming and SAT.
Display
Settings
LK 1 LK 2 LK 3 LK 4 LK 5 LK 6 LK 7 LK 8 The shaded
H → L
High to Low
PRT
1~8
L → H
Low to High
Programming Procedures
1 Go off-line.
Data
No.
2 Press LK1 + LK13 + KD to access the Memory Block.
3 Press the corresponding CO/PBX line key to change the data option.
4 Press G to write the data. The next Memory Block is displayed.
5 Program the next Memory Block or press E to go back on-line.
Related Programming
Title
0 1 / 0 4 : C H S L C = H > L
T I M E D I S P L A Y
M.B. Number Memory Block Name
7-1 Card Interface Slot Assignment
1-13-00 PRT Channel Assignment
1-13-01 PRT Signal Format Selection
1-13-03 Call by Call Service Selection
Setting
Data
1-13-05 PRT B Channel-to-Trunk Group Assignment
5-06 Trunk Group Outgoing Priority Selection
This Memory Block applies to all firmware versions of the PRT(1)-U( ) ETU.
� Notes �
selection is the
default.
System Mode
1
Submode
13
Data No.
04
PC Programming
�+AN
___________________________________________________________________________________
Programming Manual 2 - 313