Electra Elite IPK Programming Manual - Southwestern Telephone ...

___________________________________________________________________________________
Document Revision 4 Electra Elite IPK
1-15-08 Link Reconnect Allow/Deny Selection
General Description
Use this Memory Block to allow or deny the Link Reconnect feature.
Display
Settings
LK 1 LK 2 LK 3 LK 4 LK 5 LK 6 LK 7 LK 8 The shaded
NO
(Deny)
YS
(Allow)
Programming Procedures
1 Go off-line.
2 Press LK1 + LK15 + KH to access the Memory Block.
3 Press the corresponding CO/PBX line key to change the option.
4 Press G to write the data.
5 Press E to go back on-line.
Related Programming
Data
Title
No.
M.B. Number Memory Block Name
7-1 Card Interface Slot Assignment
7-3-01 MIF (LCR) Assignment
7-3-02 MIF (SMDR) Assignment
Setting
Data
0 8 : R E C O N N E C T Y S
T I M E D I S P L A Y
1-15-00 K-CCIS Main/Remote Office Selection
1-15-01 Common Signal Channel Data Speed Assignment
1-15-02 Common Signal Channel Assignment
1-15-03 Originating Point Code Assignment
1-15-04 Destination Point Code Assignment
1-15-05 Destination Point Code Transfer Assignment
1-15-06 Originating Office Code Number Assignment
1-15-07 K-CCIS Message Response Timeout Assignment
1-15-09 K-CCIS Maximum Call Forwarding Hop Assignment
selection is the
default.
System Mode
1
Submode
15
Data No.
08
PC Programming
�+AW
___________________________________________________________________________________
2 - 350 Memory Blocks