Electra Elite IPK Programming Manual - Southwestern Telephone ...

Electra Elite IPK Document Revision 4
___________________________________________________________________________________
5-06 Trunk Group Outgoing Priority
Selection
General Description
Use this Memory Block to assign the Outgoing Priority for trunk access to each Trunk
Group. This is normally used with a Tie Line or K-CCIS network to reverse the search
order and reduce call collisions during trunk seizure.
Display
Settings
LK 1 LK 2 LK 3 LK 4 LK 5 LK 6 LK 7 LK 8 The shaded
H → L
High to Low
L → H
Low to High
Programming Procedures
1 Go off-line.
Trunk
Group
(01~32)
2 Press LK5 + G +KFto access the Memory Block.
3 Press the corresponding CO/PBX line key to change the Setting Data option.
4 Press G to write the data. The next Memory Block is displayed.
5 Program the next Memory Block or press E to go back on-line.
Related Programming
Data
No.
Title
0 1 / 0 6 : P R I O R . H > L
T I M E D I S P L A Y
M.B. Number Memory Block Name
1-1-46~48 Access Code (1-, 2- or 3-Digit) Assignment
Function 201~232 – Route Advance Block 01~32
Function 401~416 – Closed Number Block 01~32
Function 601~604 – ARS Table 1~4
1-1-30 Route Advance Block Assignment
Setting
Data
1-1-49 Networking Trunk Group/Route Advance Assignment
1-14-04 ARS Trunk Group to Route Number Assignment
� Notes �
Trunk Group Mode
5
selection is the
default.
Submode
Data No.
06
PC Programming
�+ALN
This Memory Block should not be assigned (use default) for trunk groups with trunks belonging to an IAD(8)-U( )
ETU used with IP (K-CCIS) or IP (K-CCIS) to NEAX (Point-to-Multipoint).
___________________________________________________________________________________
Programming Manual 2 - 617