Electra Elite IPK Programming Manual - Southwestern Telephone ...

Document Revision 4 Electra Elite IPK
___________________________________________________________________________________
4-31 Receiving Internal/All Call Page
Selection
General Description
Use this Memory Block to specify per station whether or not an Internal Zone or
Internal All Zone Page is received.
Display
Settings
Tel
Port
No.
(01~C0)
LK 1 LK 2 LK 3 LK 4 LK 5 LK 6 LK 7 LK 8 The shaded
selection is the
YS NO
default.
Programming Procedures
1 Go off-line.
Data
No.
Title
0 1 / 3 1 : P A G I N G Y S
T I M E D I S P L A Y
2 Press LK4 + CA to access the Memory Block.
3 Press LK2 to disable Internal Zone or Internal All Zone page for Tel Port No.
Use the following to enter data:
�
Jto move the cursor left
Lto move the cursor right
K~Ito enter numeric data or Tel Port No.
– OR –
D to go to next assigned Tel Port No.
B + Ato enter A for Port Numbers 100~109
B + Bto enter B for Port Numbers 110~119
B + C3 to enter C for Port Number 120
4 Press G to write the data and display the next Memory Block.
5 Program the next Memory Block or press E to go back on-line.
1. Internal Emergency All Call Page and Internal Paging by Tenant group override this Memory Block. Refer to
Memory Block 1-1-46 [Access Code (1-Digit) Assignment].
� Notes �
2. Telephone ports A0~C0 are ports 100~120.
Setting
Data
Telephone Mode
4
Submode
—
Data No.
31
PC Programming
�+BTT
___________________________________________________________________________________
2 - 540 Memory Blocks